3.3. PoE On / Off Setting
EPoC transmitter has PoE On / Off switch. When connecting with non-PoE equipment, PoE The switch must be set
to Off.
The factory default setting of the PoE On / Off switch is OFF. Therefore, when installing transmitter with PoE devices,
the PoE switch must be set to On for power supply.
EPoC Extender is designed to be used as transceiver and when using these device as receiver with non-PoE
equipment, the PoE switch must be set to OFF.
• PoE Camera Application (PoE Switch On)
PoE IP Camera
PoE IP Camera
• Non-PoE camera application (adapter used, PoE switch off)
Non-PoE IP Camera
Non-PoE IP Camera
AC/DC Adapter(12V)
AC/DC Adapter(12V)
NOTE:
- To avoid damage of products do not connect Transmitter RJ45 PoE Out to a PoE Switch!
- Joining function by hardware is only available between Transmitter/Receiver or
Transeiver devices except camera.
95Mbps
Tx
95Mbps
Tx
95Mbps
Tx
95Mbps
Tx
Equipment Installation Guide — 19
Rx
Rx
AC/DC Adapter (56V)
AC/DC Adapter (56V)
Rx
Rx
AC/DC Adapter (56V)
AC/DC Adapter (56V)
NVR
NVR
NVR
NVR