Advertisement
Place all wires you need for servo and motor
Now start sheeting the bottom of the fuselage with the 2x12 strip ,
Mark fan unit hatch, the formers F28,F31 andF32 will be ad in when hatch is cut out.
Sand intake sheet flush with former to take 2x12mm sheeting strip
Mark front retract hatch , you can make a working hatch or make a tight fit hatch around the retract
leg.
Place 6mm scrap fill to front intake lip and sand to shape.
Clean up at the wing fairings, sand front to Place the nosecone with Dowel.
Make tail cone with F37 Place tail cone and intake diffusors, cut them in a bit at the top section to fit in
the intake and flush with the intake lining.
Advertisement
