Advertisement
might also place in the split 20mm main joiner to compare with the 14mm back joiner
Step by step glue with thin ca Make Sure not to glue the back joiner to the fuselage, you need it for the
wing. Make some strong glue joints with white glue at the wing joiner formers.
Place duct end formers F20 and Place 3x6 stringer on duct side into formers
Now place the duct sheeting and lining ,cut as per plan from thick paper in 2 pieces , it can be done in 1
piece note the cut-outs in the paper you might widen them up a bit for easy placing.
Place duct sheet from stiff paper cut as per plan. Gently push it in and glue to formers
When done place scrap 6x12mm balsa on the intake lips place 3x balsa on the ducts for strengthening
as per plan and sand flush to take fairing sheeting.
Advertisement
