Advertisement
Place wing drawing under a sheet of clear plastic.
Start by making the wing sheeting from 1,5mm balsa as per plan , see the templates for cutting the
sheets and the wing top view for the glue template , and do make oversize !
Take out all parts that are needed for the wings and clean them up with a sanding block from the small
holding tabs.
Place small parts on ribs and place 3x6 former to the mainformer,join retract plates with a sheet of
glass and epoxy or white glue for strength.
Set up the frame work with ribs and main formers
make sure the parts are sliding in smooth , to tight a fit can warp the parts , so sand if necessary.
Place formers without glue , when all parts are in ad a drop of glue here or there to hold the set.
Align all with the drawing , place the 6x12 help former under the set and nail down the parts onto the
drawing.
Advertisement
