Replacing A Light Bulb; Headlights - Meyra 2.322 Maintenance And Service Manual

Replacing a light bulb

Before changing a light bulb, observe the following:
– Switch off the operating module.
– Pull the mains-/battery fuse.
– Do not touch the glass body of the new bulb with your
bare fingers. For assembly of a new bulb you can for
example use a clean, dry cloth.

Headlights

Filament bulb:
6V/2.4W PX 13.5s
Removal
☞ To remove the lamp housing we recommend to take
off the side revetment first.
☞ For this observe chapter Revetment on page 25.
1. Turn the rear lamp housing counter-clockwise [1] by
about 15° and remove it [2]. – In doing so hold onto the
dispersion disc to prevent it from also turning.
2. Pull the defective bulb out of the dispersion disc.
Fitting
1. Insert the new bulb into the dispersion disc (2).
2. Place the rear lamp housing onto the dispersion disc
with an about 15° counter-clockwise turn [1] and turn
clockwise about 15° to let it lock into place [3]. – In do-
ing so hold onto the dispersion disc to prevent it from
also turning.
3. If necessary remount he side revetment.
28
1
2
3