Governor Speed Setting; Governor Operation - FUTABA CGY760R Manual

* Governor Speed Setting

If the governor switch is ON when the power is turned ON, the governor will not
turn ON.
Once you turn off the ON state, the governor is ready for operation. Always turn
off the governor when starting the engine.
The CGY's rpm selection is accomplished by setting the channel in section (8)
" RPM channel " menu located within the " S.BUS Basic Setting " to the governor
speed setting channel of your system. When using an independent governor on/off
switch, activate the section (7) " Governor on/off switch " function within the " Gov-
ernor Basic Setting " section earlier in this manual (page 64).
Direct set by transmitter on Gov. mixing
• When governor mixing is used to switch the RPM of the rotor head speed, the head
speed can be switched with each condition of the switch.
*For a description of the governor mixing, please refer to your transmitter's manual.
Using by 3 position switch
• Set the RPM at each switch position in the "(5) RPM setting" menu within the "Gov-
ernor Basic Setting" section earlier in this manual.

* Governor operation

The CGY operates from 700 to 4000 rpm main rotor speed. However, the engine
must be running at the set speed. The CGY turns off the governor when the engine
is starting or idling.
Condition of the governor to be on
For safety purposes, the governor is turned on when the conditions below are satisfied.
• The on/off switch conditions are set to off during power on.
• The stick switch is in the on position when it is used.
• The on/off switch is in the on position when it is used.
• Setting speed is not off.
• The engine speed exceeds to 60% of the setting speed.
• The speed sensor is working properly.
WARNING
Safety reminder: Remember to configure your transmitter fail safe settings for
not only the throttle channel but also the governor ON/OFF channel to ensure that
the governor correctly disengages should the radio enter a fail safe condition.
68