Recommended Gyro Gain Setting; Adjustments During The Test Flight - FUTABA CGY760R Manual

R
ECOMMENDED
Recommended gain settings:
The optimum sensitivity is the position just before the gyro starts hunting. To achieve
this optimum setting, it is necessary to adjust the gyro gain settings after actually fly-
ing the helicopter.
*50% is a good starting point for rudder gain regardless of model size.
A
DJUSTMENTS
Pre-flight checklist
Check that the transceiver's battery is fully charged.
Check whether the gyro tape is torn or peeled.
Turn on the transmitter / receiver and initialize the gyroscope.
Check whether the servo type setting matches the servo being used (Rudder /
Swash).
Check that the servo horn is neutral and perpendicular to the push rod. (Rudder /
Swash).
Confirm that the maximum servo movements are not physically bound through-
out the range of motion. (Rudder and swash).
Check that the gyro is operating in the correct mode (AVCS or normal) (Rudder).
Check whether the operation of each input matches the operation of the tail rotor
/ swash plate.
When rotating the aircraft body, make sure that corrective action is performed in
the correct direction.
Is the gyro sensitivity set correctly for all flight conditions? Also, check whether
it is operating in the correct mode (AVCS or normal).
G
YRO
Size
Rotor Head Gyro
450-550 45 to 55%
600-700 50 to 60%
750-more 55 to 65%
D
URING THE
G S
AIN ETTINGS
Recommended Gyro Gain
RUD Gyro
45 to 55%
50 to 60%
55 to 65%
T
EST
69
F
LIGHT