Administrator Function - finder 1T Series Manual

ADMINISTRATOR FUNCTION

From the OFF position and while holding down the center of the display for
about 1 second you can enter the "ADMINISTRATOR" configuration.
This is used to set the maximum and minimum user-adjustable temperature
values that can be set for the selected season, ie WINTER and SUMMER .
Setting the "ADMINISTRATOR" PIN can no longer be selected in Menu mode
Summer or Winter mode, or use the function of calibration.
Log in for the first time in administrator setup NO code is requested input.
If a PIN is subsequently set (other than "000"), the code request.
Entering an incorrect code displays ERR for a few moments and returns to OFF.
After 3 failed attempts you will not be able to enter any PIN for 20 seconds.
Err will remain on the display.
CAUTION
The PIN code, if lost, can not be recovered even by performing a
thermostat reset. It is advisable to write down the entered code.
NOTE
The RESET function, with ADMINISTRATOR PIN = 000, restores ALL data and
factory setting, including maximum and minimum temperature values set
within the ADMINISTRATOR function.
With ADMINISTRATOR PIN other than zero, ALL will be reset - except for the
values set within the ADMINISTRATOR function.
22