Starting The Tdc Emulator Services; Checking The Lcnp4E/Lcnp4E2 Status - Dell PowerEdge R320 Planning, Installation And Service Manual

Chapter 3 - Installation
8. Select Create New VD and press ENTER.
The Create New VD screen appears. The cursor is on the RAID Level option.
9. Press ENTER to display the RAID levels.
10. Select a RAID-5 using the arrow keys, and then press ENTER.
11. Press the TAB key and then move the cursor to the list of physical disks.
12. Press the SPACEBAR key and then select disk 00:00,00:01,00:02 and 00:03 .
13. Press TAB key and then move the cursor to Advanced Settings. Press the spacebar to make the
settings active.
14. Press TAB key and then move the cursor to Initialize. Press the spacebar to make the selection.
15. Press TAB key and then move the cursor to OK and press ENTER.
The computer prompts you with the message Initialization will destroy data on the virtual disk. Are
You Sure you want to continue.
16. Press OK.
The message Virtual disk initialization complete appears.
17. Press OK.
18. Press ESC to exit.
The message Are you sure you want to exit appears.
19. Press OK to exit from the Virtual Disk Management screen.
20. Press CTRL+ALT+DELETE to restart the server.
3.5.3

Starting the TDC emulator services

If this is a TPS node with the LCNP4E board installed, start the TDC Emulator service. Perform the
following steps to start the service.
To start the TDC emulator service
1. Choose Start > Run.
The Run dialog box appears.
2. Type services.msc.
The Services page appears.
3. Right-click TDC Emulator service and click Start.
3.5.4

Checking the LCNP4e/LCNP4e2 status

If this is an Experion "T" node or a TPS node with the LCNP4E board installed, perform the following
steps to verify the LCNP4e/LCNP4e2 passed self test.
- 36 -