Standards / Regulations - Wolf R1 Installation And Operating Instructions Manual

Installation / Commissioning
Warnings
Maintenance / Repair
4

Standards / Regulations

The boiler control unit complies with the following regulations:
EC Directives
- 2006/95/EC
- 2004/108/EC
DIN / EN Standards
EN 60335-1, EN 60730-2-9, EN 14597,
DIN 3440, EN 50165, EN 55014-1
Regarding the installation, observe the following regulations, rules
and directives.
- The installation and commissioning of the heating system
- Local EMC regulations
- DIN VDE 0100 Regulations regarding the installation of high voltage
systems up to 1000 V
- DIN VDE 105 Operation of electrical systems
- EN50156 Electrical equipment in combustion systems
- EN 12828 Heating systems in buildings
Appropriate use
The Wolf R1 control unit is designed exclusively for use in conjunction with
Wolf boilers. The R1 control unit is equipped with a temperature controller/
limiter and a high limit safety cut-out. The control unit regulates single stage
burners. The set boiler temperature can be selected between 38 - 90 °C.
The R1 control unit can be extended with a BM programming unit for
weather-compensated temperature control with time program.
Other applicable documents
Boiler installation and operating instructions.
Instructions for all accessories used.
- Never remove, bypass or disable safety and monitoring equipment.
- Only operate the system in perfect technical condition. Immediately
remove / remedy any faults and damage which may impact on safety.
- Always ensure that cold water is mixed in with hot water, when the DHW
temperature is set above 60 °C or when operating the pasteurisation
system (65 °C) (risk of scalding).
- Regularly check the perfect function of all electrical equipment.
- Only qualifi ed personnel may remove faults or repair damage.
- Only replace faulty components or equipment with original Wolf spare
parts.
- Always maintain prescribed electrical protection values (see specifi cation).
Any damage or loss resulting from technical modifi cations to Wolf control
NB
units is excluded from our liability.
Low Voltage Directive
EMC Guideline
3061809_1210