Control Unit / Function / Operation - Wolf R1 Installation And Operating Instructions Manual

Fine-wire fuse M 6.3 A
ON / OFF switch
Illuminated ring
Reset button
8

Control unit / Function / Operation

eBUS connection
for PC / Laptop
ON / OFF switch
The boiler control unit is OFF in position 0. There is no frost
protection.
Illuminated signal ring as status indicator
Display
Flashing green
Constant green light
Flashing yellow
Constant yellow light
Flashing red
Reset button
1. Resets all parameters to their factory settings.
- The operating mode switch must be set to O (OFF).
- Press and hold down the reset button whilst setting the
operating mode switch to I (ON).
- Keep holding down the reset button for at least 2 seconds
after the system has started.
2. For resetting the oil combustion unit (only in conjunction with
the relevant Wolf components)
- In case of a burner fault, the oil combustion unit is reset via
a reset relay by pressing the reset key.
Note: Reset gas fired boilers in case of a burner fault
directly at the gas combustion unit, i.e. through an
opening in the silencer hood.
Heating water temp. selection
DHW temperature selection
Explanation
Standby (power supply ON, no heat demand)
Heat demand: pump running, burner OFF
Emissions test mode
Burner ON, flame steady
Fault
High limit safety
cut-out (STB)
Operation only by
contractors
Thermometer
3061809_1210