Advertisement
Installation
Basin Mixer (No Waste) & 1 Hole
Bath Filler
1. Grub Screw
2. Lever Handle
3. Lever Handle Spacer
4. Shroud
5. Cartridge Retaining Nut
6. Cartridge
7. Tap Body
8. Anti-Splash Assembly
9. Washer
10. 'C' Shaped Rubber Washer
11. 'C' Shaped Metal Plate
12. Fixing Rods
13. Connecting Pipes
1. Identify all components are present
prior to starting installation.
2. Ensure that the washer (9) is fitted
to the underside of the tap body
(7) before fitting to the basin/bath.
Secure the 'C' shaped rubber washer
(10) and metal plate (11) into position
on the underside of the basin/bath,
using the threaded rods and nuts
(12).
Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.
x1
x1
x1
x1
x1
x1
x1
x1
x1
x1
x1
x2
x2
3. Fit the inlet connection pipes (13) by
hand only (DO NOT OVERTIGHTEN)
to the fitting and connect the hot
and cold supplies.
4. Connect the hot and cold water
supplies to the connecting pipes.
5. Turn on the water and fully open
the mixer, allowing it to run for a
few minutes and check all joints and
connections for any leaks.
7
Advertisement
