Advertisement
DRYWALLING
After the Receptor is in place and secured, proceed with the installation of drywall
another finishing surface is being used, butt the bottom of the drywall up to the top of the sealing flange. The tile can then
project over the edge of the drywall, down to the deck on single flange models, or down to the horizontal ledge on double
flange models (See Figures 1 and 2). It is important to leave a 1/8" gap between the tile (or alternative finishing surface), and
the receptor. This gap should then be closed with a silicone sealant only
Single Flange (Figure 1)
CARE & MAINTENANCE
We trust you will have many years of satisfying use from our
product. The following hints are offered to assist you in
keeping your tub and shower in "as new" condition.
Normal Care:
A quick sponge-down with warm water and a liquid detergent,
such as Mr. Clean or Fantastic, will take care of most
cleaning needs. In areas where the water is hard, more
frequent cleaning will be necessary to prevent any build up
on the surface.
We recommend the use of a good quality car or boat wax to
protect the gloss and make cleaning easier.
Stains:
For stubborn stains, start with a liquid detergent; if this does
not work, try a mild powder detergent such as Spic and Span,
which also works well for removing heavy soap film.
Cleaning pads made of nylon; saran or polyethylene and
containing no abrasives may be used.
Do not use abrasive scouring powders or metal scouring
pads, as these will permanently damage the finish.
114909-2 – 04/08/2020
(green in the figures
(do not use grout for this
Double Flange (Figure 2)
A mild abrasive action can be accomplished with an
automobile type of rubbing compound – there are several
types available, both coarse and fine. The fine ones take a
little longer to remove a stain, but they do not dull the surface
as much. Should your stain removal result in a dull area, the
shine can be restored with an automobile cleaner wax, such
as Turtle Wax.
Paint Splashes:
A quick wipe with mineral spirits, turpentine or Polyclens,
followed immediately by a wash with water will remove most
paint splashes. Do not use paint remover or stripper, as
these contain solvents that can permanently damage the
acrylic surface.
Things to Avoid:
Sand and grit. Dropped tools. Acetone on any acrylic
surface.
Should your unit suffer accidental damage, it can probably be
repaired by a qualified and trained repair person. Consult
your plumber, wholesaler or a Hytec Sales Agent to arrange
for this to be done.
4
below). If tile or
purpose).
Advertisement
