A Lexander N Eo S Eries; S Etup G Uide - Disaster Area Designs DMC.micro PRO Manual

a n s s g
lexander eo erIes etup uIde
To configure your Alexander Neo pedal with DMC.micro, plug a TS / mono cable from the
MultiJack on the DMC.micro to the MultiJack on the left side of your Neo pedal. Yes, we know
they're both called MultiJack, we made them both :)
Enter Setup on the DMC.micro and configure JACK = MIDI RNG / MID.R, then set one or more of
your device slots to ALEXANDER / ALEX. Save and exit Setup mode, then make sure that the DIP
switches on your DMC.micro are set to ON-ON-ON.
Example: If you want to use a Syntax Error as your third MIDI device you would
set DevC = ALEX in the DMC.micro Setup menu.
Power the DMC.micro on, but leave the
Neo pedal off.
Hold and release the right footswitch on the DMC.micro until the device mode that you want to
use is showing.
Example: Navigate to the C device mode - C plus a number will show.
Power on the Neo pedal while holding its center select button.
Release the button when the main LED turns violet.
Tap the center button until the upper small LED is red, then hold Select to
save.
Power the Neo pedal off and back on, again holding the center button until the upper LED turns
violet.
Tap the left or right buttons on the DMC.micro until you see the upper small
LED flash, then hold the select button to save and exit.
Your Neo pedal is now configured!
12