Table of Contents
Advertisement
5.2
Adjustment of VSET resistors
Populate a jumper in each "Vset" position to get the desired output voltage. The
silk screen marking shows the voltage settings that can be achieved by populating
jumpers.
6
Test points
Input voltage should be measured at test points VIN/GND, which are
connected directly to the VIN / GND pin of the module.
Output voltage should be measured at test points VO/GND, which are
connected directly to the VO/GND pin of the module.
7
Additional Input/output Capacitance
At the bottom side, there are places for additional input/output capacitors.
28701-ROA1286016 Rev A
R4 and R5
Figure 2 Address resistor position, R4 and R5, is shown in the picture.
2021/4/25
9 (19)
Advertisement
Table of Contents
