CipherLab 9400 Series User Manual page 49

enableWaitCursor
[in][out] A value that defines whether to enable the wait cursor while
processing an image.
0 Disable Wait Cursor
1* Enable Wait Cursor
decodingAutoexposure
[in][out] A value that defines whether to allow 2D scan engine to control gain
settings and exposure time to best capture a 2D barcode.
0 Disable Decoding Autoexposure
1* Enable Decoding Autoexposure
When Decoding Autoexposure is disabled, specify the gain and exposure
time. This parameter is only recommended for advanced users with difficult
image capture situations.
decodingIllumination
[in][out] A value that defines whether to flash illumination on every barcode
capture to aid decoding.
0 Disable Decoding Illumination
1* Enable Decoding Illumination
decodeAimingPattern
[in][out] A value that defines whether to project the aiming pattern on every
barcode capture.
0 Disable Decode Aiming Pattern
1* Enable Decode Aiming Pattern
focusMode
[in][out] A value that defines the focus mode to control the working range.
0* Far Focus — optimized to read at its far position
1 Near Focus — optimized to read at its near position
2 Smart Focus — toggles the focus position after every frame
ledIllumination
[in][out] Always 0 (Internal LED illumination)
imageAutoexposure
[in][out] A value that defines whether to allow 2D scan engine to control gain
settings and exposure time to best capture an image.
0 Disable Image Capture Autoexposure
1* Enable Image Capture Autoexposure
When Image Autoexposure is disabled, specify the gain and exposure time.
This parameter is only recommended for advanced users with difficult
image capture situations.
Chapter 2 Reader API
41