Installation - Siemens SIPART PS2 Installation Instruction

ACTUATOR MODEL AND FEEDBACK PIN
Actuator model number appears on the actuator nameplate. The table below relates actuator model to
appropriate feedback pin length. Compare pin lengths side-by-side to determine appropriate pin for
your application.

INSTALLATION

Refer to the following procedure and to the positioner and actuator installation instructions while
performing the installation. The current revision of the positioner instruction
at the Siemens Internet site. See Customer/Product Support later in this Instruction for the URL.
Before beginning the installation, note the following cautions.
CAUTION
CAUTION
Before beginning the installation, open the supplied kit(s) and check the included parts against the
parts list on page 2 and Figure 1 on page 1. Also, be sure the correct PS2 valve positioner and valve
actuator type are at hand. Each kit installation section title is in bold print. Complete the steps in each
section.
Common hand tools, including: Hex wrenches, 10mm, 1/2 , 5/16" and 3/8" wrenches, will be required.
1
PS2: SIPART PS2 Electropneumatic Positioners for Linear and Rotary Actuators, P/N A5E00074631
TABLE 1 Actuator Size and Feedback Pin
Appropriate
Actuator
Feedback Pin
Model
M-00
M-11
M-22
M-33
M-44-78
M-44-108
Do not apply supply pressure to the actuator or the valve
positioner during the installation process. Applying supply
pressure before the equipment is properly mounted could
cause unexpected movement that could lead to personal
injury or equipment damage.
Do not exceed the maximum actuator and valve positioner
air pressures stated in the manufacturer's literature.
Exceeding these ratings could cause personal injury or
equipment damage.
3
Length
2.28"
2.28"
2.28"
2.03"
2.61"
2.61"
15900-795
1
is available for download