Installation - Siemens SIPART PS2 Kit Installation Instruction

INSTALLATION

Refer to the following procedure and to the positioner and valve/actuator installation instructions while
performing the installation. The current revision of the positioner instruction
at the Siemens Internet site. See Customer/Product Support later in this Instruction for the URL.
Before beginning the installation, note the following cautions.
CAUTION
CAUTION
Before beginning the installation, open the supplied kit(s) and check the included parts against the
parts list on page 2 and Figure 1. Also, be sure the correct PS2 valve positioner and valve/actuator
are at hand. Each kit installation section title is in bold print. Complete the steps in each section.
Common hand tools, including 10mm, 7/16 and 1/2 wrenches, will be needed.
Assemble Retaining Clip to Feedback Lever (4" long arm is shown)
1. Orient the feedback lever (text side facing you) and retaining clip as shown in Figure 2. Press the
lever into the clip and lift the two hooked ends of the clip until they can be placed in two notches in
the lever and hook onto the lever. See Figure 3.
FIGURE 2, Pressing the Feedback Lever into the Retaining Clip (4" arm shown)
FIGURE 3, Placing the Retaining Clip on the Feedback Lever (4" arm shown)
1
PS2: SIPART PS2 Electropneumatic Positioners for Linear and Rotary Actuators, P/N TGX:16152-1280
Do not apply supply pressure to the actuator or the valve
positioner during the installation process. Applying supply
pressure before the equipment is properly mounted could
cause unexpected movement that could lead to personal
injury or equipment damage.
Do not exceed the maximum actuator and valve positioner
air pressures stated in the manufacturer's literature.
Exceeding these ratings could cause personal injury or
equipment damage.
3
15900-796
1
is available for download