Advertisement
4 DRIVE THE MOTOR
4.1 Operation panel (FR-DU08)
4.1.1 Components of the operation panel (FR-DU08)
No.
Component
³
·
»
¿
´
²
¶
º
¾
µ
¸
¹
20
µ
¸
¹
Name
Description
—
Not used
MON: Lit to indicate the monitoring mode.
Operation panel
status indicator
PRM: Lit to indicate the parameter setting mode.
—
Not used
—
Not used
Shows the monitored status, parameter number, etc.
Monitor (5-digit LED)
(Using Pr. 774 to Pr. 776, the monitored item can be changed.)
—
Not used
—
Not used
STOP/RESET key
Resets the converter unit when the protection function is activated.
The setting dial is used to change the parameter settings.
Press the setting dial to perform the following operations:
Setting dial
To display a a monitored item set in Pr. 992
To display a fault history number in the faults history mode
Switches to different modes.
MODE key
Holding this key for 2 seconds locks the operation. The key lock is invalid when
Pr. 161="0 (initial setting)". (Refer to the Instruction Manual.)
Enters each setting.
If pressed during operation, the
monitored item changes.
SET key
(Using Pr. 774–Pr. 776, the monitored
item can be changed.)
Goes back to the previous display.
ESC key
Holding this key for a longer time changes the mode back to the monitor mode.
—
Not used
³
·
»
Quickly flickers twice intermittently while the protective function is
activated. Slowly flickers in the display-OFF mode.
¿
´
²
¶
º
¾
When the initial setting is set.
Output
Output
frequency
current
Output
voltage
Advertisement
