16
Command status:
The device displays last command status in response to clicking/
holding a button.
•
•
Identification:
The Z-Wave controller can identify this device by signalling with LED
ring (using Indicator CC).
Custom indications:
In external supply mode, the user can use the LED ring to display
custom indications. Using the Z-Wave controller user can specify on
which half of the ring to indicate, number of blinks and timing (using
Indicator CC). Brightness and colour of the indications is specified in
parameters 13, 150 and 151.
7.7: Menu
Menu allows to perform Z-Wave network actions. In order to use the
menu:
1. Quickly, three times click, then press and hold one of the
2. After 3 seconds LED ring signals adding status:
3. The LED ring will turn off for 3 seconds, then start signalling
4. Release the button when device signals desired position with
operatIon
Green for 2 seconds – command acknowledged,
Red for 2 seconds – command not acknowledged.
buttons.
•
Blinking green – entering the menu (added as non-secure, S0,
S2 non-authenticated)
•
Blinking magenta – entering the menu (added as Security S2
Authenticated)
•
Blinking red – entering the menu (not added to a Z-Wave
network)
menu positions.
colour:
•
WHITE – wake up the device
•
GREEN – start learning mode (add/remove)
•
MAGENTA – test Z-Wave range
•
CYAN – show battery level
» Green – 50-100%
» Yellow – 16-49%
» Red – 1-15%
•
YELLOW – reset to factory defaults