Table of Contents
Advertisement
10
5.2: Adding using SmartStart
SmartStart enabled products can be added into a Z-Wave network
by scanning the Z-Wave QR Code present on the product with a con-
troller providing SmartStart inclusion. SmartStart product will be
added automatically within 10 minutes of being switched on in the
network range.
To add the device to the Z-Wave network using SmartStart:
1. To use SmartStart your controller needs to support Security S2
2. Enter the full DSK string code to your controller. If your controller
3. Power the device.
4. Wait for the adding process to start (up to few minutes), which is
5. Adding result will be confirmed by the Z-Wave controller's
aDDIng to Z-Wave netWork
(see the controller's manual).
is capable of QR scanning, scan the QR code placed on the label
on the box.
signalled with yellow LED blinking.
message and the LED frame:
•
Green – successful (non-secure, S0, S2 non-authenticated),
•
Magenta – successful (Security S2 Authenticated),
•
Red – not successful.
In case of problems with adding the device, please reset
i
the device and repeat the adding procedure.
Advertisement
Table of Contents
