Pottery Barn CLASSIC RATTAN FULL BED Assembly Instructions

•
Please read all instruction before beginning assembly.
• For ease of assembly, assembly by two people is recommended.
•
Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or
hardware.
BOX 1 ( 60 ¾" X 59 ¾" X 10 ½" )
Parts Inside:
•
(1) Head Board
•
(1) Foot Board
•
(1) Hardware Pack including:
- (32) Wood Screws for Slats
BOX 2 ( 80 ¾" X 9 ¾" X 11" )
Parts Inside:
•
(2) Side Rails
•
(1) Slat roll including 16 slats
Tools Required:
•
Phillips Screwdriver (not included)
Assembly Instructions:
1. Place the Headboard and Footboard near the desired location for the bed. Figure 1.
2. Locate the groove of each post, where the pin is inserted.
3. Align one side rail with hook at end to post.
Insert the hook of the side rail into the groove of the post, slowly
push downward to tighten the hook to the pin. Figure 2.
4. Repeat steps 2 and 3 until both side rails are completely
attached.
CLASSIC RATTAN FULL BED
Assembly instructions
Figure 1
Headboard
Footboard
Figure 2
Post
Side Rail
Hook
Pin