Pottery Barn CLASSIC LADDER SHELF Assembly Instructions

Important Safety Instructions:

Please read all instructions carefully before assembling.
•
For your safety, assembly by two people is recommended.
•

Parts Included:

(Box 1 of 1)
(1) Ladder Shelf (A)
•
(2) (Long) Back Support (B)
•
(2) (Short) Back Support (C)
•

Pre-Assembly:

Remove all parts and hardware from the box and lay out on a clear workspace, along with any plastic protective
•
packaging. Do not dispose of any contents until assembly is complete to avoid accidentally discarding small parts or
hardware.
Use the parts and hardware lists above to identify and separate each of the pieces included.
•
The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
•
Note: Fully tighten all connecting bolts. Failure to follow these instructions may cause the bolts to misalign during
•
assembly.
Assembly Instructions:
1. Turn the Ladder (A) over on a carpeted or scratch free surface so the back is facing upwards.
2. Attach (4) connecting bolts (E) to the ladder into the corresponding pre-drilled holes and tighten with a
screwdriver.
3. Insert (4) fasteners (D) into the corresponding pre-drilled holes on the back supports (B and C). Attach to
connecting bolts and tighten fasteners with the screwdriver. Fig. 1
4. Grasp ladder at each end and carefully turn upright. Fig. 2
B
C
E
CLASSIC LADDER SHELF
Assembly Instructions
Hardware Enclosed:
(4) Fastener (D)
•
(4) Connecting Bolt (E)
•
(2) Anchor (F)
•
(2) Screw (G)
•
(1) Mounting Template
•
A
D
Fig. 1
Tools Required:
Screwdriver (not included)
•
Fig. 2