Visual Productions B-STATION2 Manual page 25

By briefly pressing the reset button on the back of the device it toggles
between static and automatic IP addresses. When switching modes, the
B-Station2's leds will briefly flash in red for DHCP, or in white for static.
By pressing and holding the reset button (see figure 5.2) on the device for
3 seconds, it will reconfigure the unit to the factory default IP address and
subnet mask. No other settings will be changed. The default IP address
is 192.168.1.10 with the subnet mask set to 255.255.255.0.
5.2 Web-interface
The B-Station2 features an inbuilt web-server. This web-interface can be ac-
cessed via a standard browser. It is recommended to use any of the following
browsers:
Microsoft Edge
Google Chrome (v83 or higher)
Apple Safari (v13 or higher)
Mozilla Firefox (v54 or higher)
The web-interface enables you to configure and program the B-Station2. When
browsing to the unit the home page (figure 5.3) will appear first. The home
page is read-only; it provides information but does not allow for changing any
setting. The other pages present many settings that can be edited. These pages
will be discussed in the subsequent chapters.
Figure 5.3: Home page
25