HIKVISION HiLook Quick Start Manual page 12

inférieur) approuvé pour l'émetteur
par Industrie Canada. Dans le but de
réduire les risques de brouillage
radioélectrique à l'intention des
autres utilisateurs, il faut choisir le
type d'antenne et son gain de sorte
que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas
l'intensité nécessaire à
l'établissement d'une
communication satisfaisante.
This equipment should be installed
and operated with a minimum
distance 20cm between the radiator
and your body.
Cet équipement doit être installé et
utilisé à une distance minimale de
20 cm entre le radiateur et votre
corps.
Safety Instructions
Warnings
Laws and Regulations
The device should be used in
compliance with local laws, electrical
safety regulations, and fire
prevention regulations.
Electrical Safety
CAUTION: To reduce the risk of fire,
replace only with the same type and
rating of fuse.
Battery
This equipment is not suitable for
use in locations where children are
likely to be present.
CAUTION: Risk of explosion if the
battery is replaced by an incorrect
type.
Improper replacement of the battery
with an incorrect type may defeat a
safeguard (for example, in the case
of some lithium battery types).
Do not dispose of the battery into
fire or a hot oven, or mechanically
crush or cut the battery, which may
result in an explosion.
Do not leave the battery in an
extremely high temperature
surrounding environment, which
may result in an explosion or the
leakage of flammable liquid or gas.
Do not subject the battery to
extremely low air pressure, which
may result in an explosion or the
leakage of flammable liquid or gas.
Dispose of used batteries according
to the instructions.
Cautions
Fire Prevention
No naked flame sources, such as
lighted candles, should be placed on
the equipment.
The serial port of the equipment is
used for debugging only.
Hot Surface
CAUTION: Hot parts! Burned fingers
indicate that the marked item can be
hot and should not be touched
without taking care. Wait one-half
hour after switching off before
handling parts.
The device with this sticker is
intended for installation in a
restricted access location. Access can
only be gained by service persons or
by users who have been instructed
about the reasons for the restrictions
applied to the location and about
any precautions that shall be taken.
Installation
Install the equipment according to
the instructions in this manual.
To prevent injury, this equipment
must be securely attached to the
ceiling/wall in accordance with the
installation instructions.
Be sure that there is enough space to
install the device and accessories.
Make sure that the wall is strong
enough to withstand at least 8 times
11
when handling the
parts.
This sticker is to