HIKVISION HiLook Quick Start Manual page 11

between the radiator and
your body.
FCC Conditions
This device complies with part 15 of
the FCC Rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful
interference.
2. This device must accept any
interference received, including
interference that may cause
undesired operation.
EU Conformity Statement
This product and - if
applicable - the supplied
accessories too are
marked with "CE" and comply
therefore with the applicable
harmonized European standards
listed under the Low Voltage
Directive 2014/35/EU, the EMC
Directive 2014/30/EU, the RoHS
Directive 2011/65/EU, and RE
Directive 2014/53/EU.
2012/19/EU (WEEE
directive): Products
marked with this symbol
cannot be disposed of as
unsorted municipal waste
in the European Union. For proper
recycling, return this product to your
local supplier upon the purchase of
equivalent new equipment, or
dispose of it at designated collection
points. For more information, please
see: www.recyclethis.info.
2006/66/EC (battery
directive): This product
contains a battery that
cannot be disposed of as
unsorted municipal waste
in the European Union. See the
product documentation for specific
battery information. The battery is
marked with this symbol, which may
include lettering to indicate cadmium
(Cd), lead (Pb), or mercury (Hg). For
proper recycling, return the battery
to your supplier or to a designated
collection point. For more
information, please see:
www.recyclethis.info.
Industry Canada ICES-003
Compliance
This device meets the CAN ICES-3
(B)/NMB-3(B) standards
requirements.
This device complies with Industry
Canada licence-exempt RSS
standard(s). Operation is subject to
the following two conditions:
(1) this device may not cause
interference, and
(2) this device must accept any
interference, including interference
that may cause undesired operation
of the device.
Le présent appareil est conforme aux
CNR d'Industrie Canada applicables
aux appareils radioexempts de
licence. L'exploitation est autorisée
aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de
brouillage, et
(2) l'utilisateur de l'appareil doit
accepter tout brouillage
radioélectrique subi, même si le
brouillage est susceptible d'en
compromettre le fonctionnement.
Under Industry Canada regulations,
this radio transmitter may only
operate using an antenna of a type
and maximum (or lesser) gain
approved for the transmitter by
Industry Canada. To reduce potential
radio interference to other users, the
antenna type and its gain should be
so chosen that the equivalent
isotropically radiated power (e.i.r.p.)
is not more than that necessary for
successful communication.
Conformément à la réglementation
d'Industrie Canada, le présent
émetteur radio peut
fonctionner avec une antenne d'un
type et d'un gain maximal (ou
10