Fronius TransSteel 2200 Operating Instructions Manual page 97

Setting range: 0 - 200
Factory setting: 100
I-E Final current
Unit: % of welding current
Setting range: 0 - 200
Factory setting: 50
t-S Start current duration
Unit: seconds
Setting range: 0 - 9.9
Factory setting: 0
t-E Final current duration
Unit: seconds
Setting range: 0 - 9.9
Factory setting: 0
Fdi Feeder inching speed
Unit: m/min (ipm)
Setting range: 1 - 18.5 (39.37 - 728.35)
Factory setting: 10 (393.7)
Ito Length of wire that is fed before the safety cut-out trips
Unit: mm (in.)
Setting range: OFF, 5 - 100 (OFF, 0.2 - 3.94)
Factory setting: OFF
The "Ignition time-out" function (Ito) is a safety function. If the power source
determines that no ignition has occurred after the preset wire length has been
fed, wirefeeding is stopped.
SPt Spot welding time
Unit: seconds
Setting range: 0.3 - 5
Factory setting: 1
SPb Spot pause time
Unit: seconds
Setting range: OFF, 0.3 - 10 (in 0.1 s increments)
Factory setting: OFF
Int Interval
Unit: -
Setting range: 2T (2-step), 4T (4-step)
Factory setting: 2T (2-step)
FAC Reset power source to factory settings
Press and hold one of the "Parameter selection" buttons for two seconds to
restore the factory settings
- when "PrG" appears on the digital display, the power source has been reset.
97