Fronius TransSteel 2200 Operating Instructions Manual page 132

Type of cooling
Overvoltage category
Pollution degree according to IEC60664
EMC device class
Safety markings
Dimensions l x w x h
Weight
Max. shielding gas pressure
Wire speed
Wire drive
Wire diameter
Wirespool diameter
Wirespool weight
Max. noise emission (LWA)
Idle state power consumption at
230 V
Power source efficiency at
210 A / 24.5 V
1)
2)
3)
4)
132
Interface to a 230 V, 50 Hz public grid.
Only applies to USA:
If an automatic circuit breaker is used instead of a fuse, the current/time charac-
teristic of the automatic circuit breaker must match that of the mains fuse spe-
cified above.
It is permitted for the tripping current of the automatic circuit breaker to be higher
than the tripping current of the mains fuse specified above.
Only applies to USA:
Time-delay fuse conforming to UL Class RK5 (see UL 248).
A device in emissions class A is not intended for use in residential areas in which
the electrical power is supplied via a public low-voltage grid.
The electromagnetic compatibility may be influenced by conducted or radiated
radio frequencies.
AF
III
3
4)
A
S, CE, CSA
560 x 215 x 370 mm
22.05 x 8.46 x 14.57 in.
15.2 kg
33.51 lb.
5 bar
72.52 psi
1.5 - 18 m/min
59.06 - 708.66 ipm
2-roller drive
0.6 - 1.2 mm
0.025 - 0.047 in.
max. 200 mm
max. 7.87 in.
max. 6.8 kg
max. 14.99 lb.
65.5 dB
17.4 W
89 %