Fronius TransSteel 2200 Operating Instructions Manual page 33

(6)
(6) "Parameter selection" button (left)
For selecting the parameters listed below
The relevant symbol lights up when a welding parameter is selected.
Sheet thickness in mm or inch (synergic parameter)
If, for example, the welding current to be selected is not known, entering the
sheet thickness alone is sufficient. Entering one synergic parameter means that
all other synergic parameters are set automatically.
Welding current in amperes (synergic parameter)
Before welding begins, the device automatically displays a standard value based
on the programmed parameters. The actual value is displayed during welding.
Wire speed in m/min or ipm (synergic parameter)
1
If one of these parameters is selected in the MIG/MAG standard synergic welding pro-
cess, then the synergic function ensures that all other synergic parameters are adjusted
automatically.
1
1
1
33