Fronius TransSteel 2200 Operating Instructions Manual page 120

no | IGn
Cause:
Remedy:
no | ARC
Cause:
Remedy:
EPG | 17
Cause:
Remedy:
EPG | 35
Cause:
Remedy:
120
"Ignition time-out" function is active; current did not start flowing before the
length of wire specified in the Setup menu had been fed. The power source
safety cut-out has tripped
Shorten the wire stick-out; press the torch trigger again; clean the surface of
the workpiece; if necessary, set the "Ito" parameter in the Setup menu
Arc break during TIG welding
Press the torch trigger repeatedly, clean the surface of the workpiece
The selected welding program is invalid
Select a valid welding program
Measurement of the welding circuit resistance failed
Check grounding cable, current cable, or hosepack and replace if neces-
sary, re-measure the welding circuit resistance