Toshiba MMY-MUP0801HT8JP Service Manual page 273

No. Part
3 WARNING
Heat
exchanger
Wear a pair of gloves.
Otherwise, you will risk an injury involving a replacement
part or some other object.
1. Detachment
1) Remove No. 1. Cabinet, No.2. propeller fan/fan motor,
and No. 5. Reactor. (Only 14A~24HP)
2) Remove the discharge cabinet, motor base, beams in
four sides, and two rear supports.
<8 to 14HP(Fig.1)>
Discharge cabinet : Screws M5×10, 8 pcs
Motor base : M5×10, 4 pcs
Beams in four sides : M5×10, 21 pcs
Rear supports : M5×10, 6 pcs
<14A to 24HP(Fig.2 to 4)>
Discharge cabinet : M5×10, 12 pcs, M4×14, 2 pcs
Closing panel : M5×10, 3 pcs
Fixing board : M5×10, 3 pcs
Upper beams : M5×10, 2 pcs
Motor base : M5×10, 8 pcs
Beams in four sides : M5×10, 23 pcs
Rear supports : M5×10, 6 pcs
Work procedure
M5×10
Rear: 2 pcs
Side: 1 pcs
Fig. 5
- 273 -
Remarks
<8 to 14HP>
Discharge cabinet
M5×10, 8 pcs
Fig. 1
<14A to 24HP>
Discharge cabinet
M5×14, Upper side: 2 pcs
M5×10, 6 pcs ×2
Fig. 2
Support
Closing panel
Motor base
Fixing board
M5×10,
Closing panel: 3 pcs
A beam on all sides
Fixing board: 4 pcs
Upside beam: 2 pcs
Motor base: 8 pcs
Fig. 3
M5×10,
Back beam: 8 pcs
Left / Right beam: 7 pcs×2
Fig. 4