Toshiba MMY-MUP0801HT8JP Service Manual page 126

(Indoor address)
8
Push the menu button to make Code No. flash. Change Code No. to 13 with [
setting button.
9
Push the menu button to make Set data [****] flash. Set the indoor unit address with
[ ] [ ] setting button.
(TU2C-LINK : 0001~0128
TCC-LINK : 0001~0064)
10
Push the Timer off button.
(When the display changes from [– –] to Set data [****] flashing, the setup is completed.)
(Group address)
11
Push the menu button to make Code No. flash. Change Code No. to 14 with [
setting button.
12
Push the menu button to make Set data [****] flash. Set the group address with
[ ] [ ] setting button.
If the indoor unit is individual, set the address to ‚0000 ; header unit, 0001 ; follower unit,
0002.
13
Push the Timer off button.
(When the display changes from [– –] to Set data [****] flashing, the setup is completed.)
(Central control address)
14
Push the menu button to make Code No. flash. Change Code No. to 03 with [
setting button.
15
Push the menu button to make Set data [****] flash. Set the indoor unit address with
[ ] [ ] setting button.
(TU2C-LINK : 0001~0128
TCC-LINK : 0001~0064)
16
Push the Timer off button.
(When the display changes from [– –] to Set data [****] flashing, the setup is completed.)
17
When all the settings have been completed, push ON/OFF button to determine the
settings.
" SETTING " flashes and then the display content disappears and the air conditioner enters the normal stop
mode. (The remote controller is unavailable while " " is flashing.)
SETTING
- 126 -
] [ ]
] [ ]
] [ ]