Dual Video Mode; Dual Video Connection; Dual Video Disconnection - Aethra AVC500 Use And Installation Manual

Aethra avc500: user guide

Hide thumbs Also See for AVC500:

Table of Contents

Dual Video Mode

You can create a Dual Video connection to send two video streams originating from different sources .

This is feasible on the condition that the remote terminal supports Dual Video. Dual Video transmissions can be

initiated by either the Audio-Video calling or called terminal. If the receiving terminal is set up with XGA output,

and one of the received streams is an XGA stream, this one will be automatically displayed into XGA output.

However, the user is able to switch the automatic disposition by pressing the "C" key on the remote control.

To create a Dual Video connection:

1) Set up a normal audio-video connection with the desired terminal

2) Press the "Dual" key on the remot control

3) Select the desired second video input source from the drop-down menu

4) Move to the YES icon and press OK

Once Dual Video is activated, if the receiving terminal is set up with two monitors, the user will be able to see the two video

streams simultaneously. If there is only one monitor, the user can switch between the video streams by pressing the "SELF"

key on the remote control.

To disconnect Dual Video only:

1) Press the "Dual" key on the remote control.

2) Move to the icon "Yes" and press OK.

Note

To disconnect the whole Videoconference press the "Disconnect" key on the remote control.

Table of Contents