Epson ES-580W User Manual page 91

Preparing to Scan over a Network
Configuring the LDAP Server
To use the LDAP server information, register it on the scanner.
1. Access the Web Config and select the Network tab > LDAP Server > Basic.
2. Enter a value for each item.
3. Select OK.
The settings you have selected are displayed.
LDAP Server Setting Items
Items
Use LDAP Server
LDAP Server Address
LDAP server Port Number
Secure Connection
Certificate Validation
Search Timeout (sec)
Authentication Method
Kerberos Realm to be Used
Administrator DN / User Name
Password
>
Making Contacts Available
Settings and Explanation
Select Use or Do Not Use.
Enter the address of the LDAP server. Enter between 1 and 255 characters of
either IPv4, IPv6, or FQDN format. For the FQDN format, you can use alphanumeric
characters in ASCII (0x20-0x7E) and "- " except for the beginning and end of the
address.
Enter the LDAP server port number between 1 and 65535.
Specify the authentication method when the scanner accesses the LDAP server.
When this is enabled, the certificate of the LDAP sever is validated. We
recommend this is set to Enable.
To set up, the CA Certificate needs to be imported to the scanner.
Set the length of time for searching before timeout occurs between 5 and 300.
Select one of the methods.
If you select Kerberos Authentication, select Kerberos Settings to make
settings for Kerberos.
To perform Kerberos Authentication, the following environment is required.
❏ The scanner and the DNS server can communicate.
❏ The time of the scanner, KDC server, and the server that is required for
authentication (LDAP server, SMTP server, File server) are synchronized.
❏ When the service server is assigned as the IP address, the FQDN of the service
server is registered on the DNS server reverse lookup zone.
If you select Kerberos Authentication for Authentication Method, select the
Kerberos realm that you want to use.
Enter the user name for the LDAP server in 128 characters or less in Unicode
(UTF-8). You cannot use control characters, such as 0x00-0x1F and 0X7F. This
setting is not used when Anonymous Authentication is selected as the
Authentication Method. If you do not specify this, leave it blank.
Enter the password for the LDAP server authentication in 128 characters or less in
Unicode (UTF-8). You cannot use control characters, such as 0x00-0x1F and 0X7F.
This setting is not used when Anonymous Authentication is selected as the
Authentication Method. If you do not specify this, leave it blank.
91
>
Cooperation between the LDAP Server
...