Installing The Display Panel (Nontouch); Camera Microphone Module; Removing Camera-Microphone Module - Dell Latitude 7290 Owner's Manual

Installing the display panel (nontouch)

NOTE: The display panel installation procedure is applicable only for nontouch display configuration.
1. Connect the display cable on the back of the display panel.
2. Affix the mylar tape securing the display cable on the back of the display panel.
3. Affix display connector adhesive strip to the display panel.
4. Flip the display panel over and slide the display panel towards the system.
5. Replace the two (M2.0 x 2.0) screws on the panel.
6. Install the:
a. Bezel
b. Hinge Cap
c. display assembly
d. WLAN card
e. WWAN card
f. battery
g. base cover
7. Follow the procedure in

Camera Microphone Module

Removing camera-microphone module

The removal procedure of the microphone camera module is only for a nontouch display configuration.
1. Follow the procedure in
2. Remove the following:
a. base cover
b. battery
c. WLAN card
d. WWAN card
e. display assembly
f. bezel
g. display hinge
3. To remove the camera microphone module:
a. Peel off the two pieces of conductive tape covering the camera microphone module [1].
NOTE: The conductive tape is a separate part from the camera module that must be removed and then reattached
when replacing the camera microphone module.
b. Lift the camera microphone module [2].
c. Disconnect the camera cable from the camera module [3].
d. Lift and remove the camera microphone module [4].
36 Removing and installing components
After working inside your
Before working inside your
computer.
computer.