Dell Latitude 7290 Owner's Manual page 29

3. To remove the display assembly:
a. Un route the WLAN and WWAN cables from the routing channels [1].
b. Remove the M2.0 x 3.0 screws that secure the eDP bracket [2].
c. Lift the eDP bracket from the eDP cable [3].
d. Lift the eDP cable to disconnect it from the connector on the system board [4].
e. Un route the eDP cable from the routing channel [5].
NOTE: When removing the display assembly or system board, the display bracket must be removed and the piece of
tape adhered to the power-adapter connector on the system board must be peeled back in order to disconnect the
display cable.
4. To remove the display assembly:
a. Open the display of the computer and lay it on a flat surface at 180-degree angle
b. Remove the six (M2.5 x 3.5) screws that secure the display hinge to the display assembly [1].
c. Lift the display assembly from the system.
Removing and installing components 29