Pairing; Unpairing - F&F FW-WS3 Manual

Pairing

If the pairing is correct, the output circuit will be momentary switched off
and the LED in the receiver will switch on again.
Exit from the programming mode of the receiver occurs automatically
after 30 seconds of waiting for a signal from the transmitter or by briefly
pressing the PROG button.
Each channel of the receiver can be paired with eight different transmit-
ters (remote buttons). Pairing with more buttons will remove the first en-
tries made in the receiver.

Unpairing

Unpairing of the wall button from the receiver is only possible by clearing the list of all trans-
mitters in the receiver. To clear the list of transmitters cooperating with the receiver, press and
hold the PROG button for a minimum of 10 seconds. Fast flashing of the communication LED
indicates that the memory of the controller is cleared.
After you successfully connect the receiver, press and
hold the PROG button until the device switches on the
output circuit and the communication LED goes off.
Press the selected button.
- 3 -