Water Separator - BÖWE P 12 Instruction Manual

11 Maintenance

11.5.2 Water separator

To prevent odor buildup, drain the water trap daily into the process water tank or into the safety
separator.
Dispose of the process water according to the regulations in your country.
Work sequence:
- Open ball valve (1) and lower the solvent level to below the lower edge of the drain pipe (2)
- Close ball valve (1)
- Open ball valve (2) and drain water phase
- Close ball valve (2)
Drain the entire contents of the water separator once a week.
There are 2 steps. In step 1, drain the water trap as described above.
In step 2, drain the entire residue into the still.
Work sequence for step 2:
- Open ball valve (1) until the water separator is empty
- Close ball valve (1)
- Clean water separator if necessary
- Remove safety flap plug (7)
- Open sight-glass clamp (3) and remove sight-glass with gasket
- Clean water separator and sight-glass
- Replace sight-glass with gasket and close the clamp
- Insert safety flap plug (7) and snap spring clip into place
62
707757-04-0A
11
P12