Maintenance Work Instructions; Lint Filter/Button Trap - BÖWE P 12 Instruction Manual

11 Maintenance
Pump solvent out of the machine
Pressure side of the pump:
Start manual program from tank 1 or tank 2 and tank 3 and pump out solvent.
If the tank does not empty out, you must start the required program again.

11.5 Maintenance Work Instructions

Note that after cleaning the solvent tanks:
You must check covers, sight-glasses or doors that you opened for
leaks when you fill the tanks again.
Make sure that the machine is turned off and secured before performing any maintenance work.
Observe safety regulations concerning the handling of solvent (see Point 2).
Only trained service personnel who are familiar with the machine are authorized to maintain the
machine.

11.5.1 Lint Filter/Button Trap

The button trap and lint filter are combined in a common maintenance unit with a single maintenance
opening.
You must perform the maintenance of the lint filter and the button trap daily before the start of the 1st
cycle.
Sequence of the maintenance work on the lint filter:
- Loosen the cover fastener and open the cover.
- Remove the lint filter basket.
- Remove and clean the lint filter mat from the filter basket (wash if necessary).
- Check the lint filter mat for any damage.
- Place cleaned lint filter mat on to the filter basket and secure properly.
Attention: Never work without the lint filter insert and never use
- Then perform the button trap maintenance.
Sequence of the maintenance work on the button trap:
- Remove strainer insert.
- Clean strainer insert and put it back in place.
Attention: Never work without a strainer insert - the pump could be
damaged by foreign bodies!
Attention: Perform maintenance only when the machine has been
turned off and after the drying has finished.
- Then insert the lint filter basket and make sure that it is securely in place.
- Clean the cover gasket
- Firmly close the cover of the common maintenance opening
Remove cap
Connect hose to barrel
damaged lint filter mats.
61
11
11.5
P12