Refilling Solvent; Filling The Slimsorba Carbon Container (Optional Equipment) - BÖWE P 12 Instruction Manual

6 Operation
To fill without emissions, proceed as follows:
- Remove the screw cap on the pump line.
- Connect a hose between the barrel and pump suction side.
- Connect gas displacement line between the barrel and water separator.
- Open the ball valve.
- Start program P37.
- The tanks fill up, with one overflowing into the other.
- Watch the level of the liquid in the tanks and stop program P37 when the tanks are full.
- Close the ball valve.
- Remove the connecting lines to the barrel.
- Screw the cap back on to the pump line.
- Remove the gas displacement line.
6.1.3

Refilling Solvent

Follow the procedure given in Point 6.1.2 for routine refilling of solvent.
Attention: Even empty containers can still hold solvent residues.
6.1.4

Filling the Slimsorba Carbon Container (Optional Equipment)

- Loosen the upper tube of the carbon container (disassemble hose connections, sensor and
aeration line).
- Loosen the quick release fastener on the cover and remove cover.
- Remove fine filter sieve and clamping ring.
- Fill in 10 kg (22 lb) of activated carbon (cylindrical pellets with approx. 4 mm (0.16 inch) diameter,
type Supersorbon K40). The heating coil must be covered.
- Replace the fine filter sieve and clamping ring.
- Replace the cover and close the quick release fastener.
- Secure the upper tube of the carbon container again (assemble hose connections, sensor and
aeration line).
Attention: Perc is a powerful fat solvent. Wear gloves when handling
perc and apply protective skin ointment to hands when done. Do not
smoke when handling perc. If you get perc in your eyes, seek further
medical care.
You must fill the pump with solvent before turning it on.
Check that the direction of rotation is correct.
Therefore, tightly seal the container (barrel) again and
store or dispose of in accordance with regulations!
22
6
P12