Advertisement
Step 12
Lay the doors onto a smooth flat surface so the holes are facing upwards. Screw 4x soft closing hinges
(E) to top and bottom, 2x hinges (D) to the middle of the doors using 12x screws ( G ) as shown. See Clip top
BLUMOTION instructions for soft closing hinge details.
G - (3,5 x 16)
D - Hinge
90º
Step 13
Before adjusting the doors, use a spirit level to check the Base (or Top) of the unit is level front-to-back
and side in the 3 positions shown. Use alignment wedges ( M ) to make the unit level BEFORE making any
adjustment to the hinges as shown.
(İ) HEIGHT ADJUSTMENT
Loosen screws 'A' on fixing plates and move Door up or down as required. Retighten screws 'A'.
(İİ) FORWARD or BACKWARDS ADJUSTMENT
Loosen screw 'B' on fixing plate and move Door in or out as required. Retighten screw 'B'.
(İİİ) SIDEWAYS ADJUSTMENT
To move Door 'OUT' at hinge position, slacken screw 'C' slightly, then tighten screw 'B'. To move Door 'IN' at
hinge position, slacken screw 'B' slightly then tighten screw 'C'.
E - Soft Closing
Hinge
G
G
K
Page 9 of 12
E
D
E
L
9
10
E
D
E
A
(İ)
B
(İİ)
C
(İİİ)
Advertisement
