Juniper SRX300 Hardware Manual page 43

Figure 4: Attaching Wall-Mount Brackets
SR X3 0 0
3. Use a number-2 Phillips screwdriver to install the screws that secure the mounting brackets to the
chassis.
4. If you are using wall anchors to support the chassis, install two pairs of anchors on the wall with the
mounting brackets attached.
5. Have one person grasp the sides of the device, lift it, and position it on the wall.
shows the four different orientations in which you can mount the services gateway on a wall.
Figure 5: Orienting the SRX300 Services Gateway on a Wall
6. Have a second person install two pairs of mounting screws through the bracket holes on either side of
the device to secure it to the wall.
7. Verify that the mounting screws on one side are aligned with the mounting screws on the opposite
side and that the device is level (see Figure 6 on page 44).
Figure 5 on page 43
43