Optional Timer/ Duration Remote Operations; Timer/ Duration Remote Led Indicator - Ultratec 9D Operator's Manual

Optional Timer/ Duration Remote Operations

The Timer/ Duration Remote offers Duration, Interval, Variflow and fog on/ off controls.
Timer/ Duration Remote LED
Indicator
The Timer/ Duration Remote Handset was designed to indicate operation
modes.
These are as follows:
Slow Flashing Light: Indicates unit is not ready to operate but still in
heating mode, fog is not available at this point.
Quick Flashing Light: Indicates unit is ready to operate but still in heating
Solid Light: Indicates that the unit is ready to fog at full output.
Triple Pattern Flashing Light: Indicates that the unit is in an over
No Light: Indicates problems; a loss of power or remote is not connected. If these fail to correct the problem,
contact your local Ultratec Special Effects dealer.
Variflow Sets the desired fog output rate from 0 to full output.
Duration Sets fog "on time" from 0-4.25 minutes when using the timer settings.
Interval Sets fog "off time" from 0-4.25 minutes when using the timer settings.
The interval time must be set to 0 to disable the timer operation.
Note: To operate the Eclipse Low Fog Generator using the Timer/ Duration Remote, the DMX Address must
be set on 555 and the Duration control set over 50%. If the Duration is set at anything less than
50%, the Switched Power Port will be off.
The Show Control Remote and Timer/ Duration Remote cable may be extended from the machine and
operated effectively away from the Power Fogger 9D.
The maximum allowable extension cable length is 200 Feet, less is better.
5
www.ultratecfx.com
mode, some fog is available at this point.
temperature condition and has shut down.
Duration Dial Interval Dial
DURATION INTERVAL
VARIFLOW
Flow Dial
FOG
Smoke OFF/ON Switch
Optional Timer/ Duration Remote
LED