Advertisement
PAD MODE CHORD Added
"chord mode"
A
that lets you use the pads to play chords is added as a
choice of PAD MODE.
You can save up to 13 chords in one project.
Switching to chord mode
1.
While in NOTE mode, press the
The unit switches to chord mode, and the [NOTE] button blinks.
Press the [NOTE] button once again to return to NOTE mode.
Editing a chord
1.
Hold down the
[SHIFT] button
The CHORD DESIGNER appears.
Controller
Explanation
[VALUE] dial
Changes the item shown.
[SOUND] button
Previews the sound of the chord.
Select the pad to which the chord is written.
PAD [2], [3], [5], [6], [7], or
The chord is saved when you hold down the [SOUND]
[9]–[16]
button and press a pad.
Parameter
Explanation
KEY
Specifies the note that will be the key of the scale.
Specifies the scale from which the chord is extracted.
SCALE
& For details on scales, refer to "List of scales (when KEY is C)" (p. 9)
ROOT
Specifies the root note of the chord.
Specifies the constituent notes.
SPREAD
The displayed numbers indicate the scale degree of each note,
with the root as 1.
When you press the [VALUE] knob, the chord is saved in the
>>WRITE PAD
selected pad.
[NOTE]
button.
and press the
[FILTER]
button.
MC-101 Update
Parameters Added
The following parameter is added to the TONE SETTING/KIT SETTING
screen.
Parameter
Value
Explanation
Adjusts the volume of the mixed sounds.
This lets you adjust the overall track volume while
Mix Level
0–127
preserving the volume changes even when motion is used
to vary the Level parameter.
The following parameters are added to the drum track pad settings.
Parameter
Value
Explanation
Sets the way sounds are played when the same pad is
pressed a number of times.
MULTI:
continuous sounds where the sound plays for an extended
MULTI,
time, such as with crash cymbals, the sounds are layered,
Voice
SINGLE
without previously played sounds being eliminated.
SINGLE:
same pad is pressed. With continuous sounds where the
sound plays for an extended time, the previous sound is
stopped when the following sound is played.
Specifies the behavior when a pad is pressed.
NO-SUS:
NO-SUS,
EnvMode
you press the pad.
SUSTAIN
SUSTAIN:
pad.
The following parameter is added to the MOTION DESIGNER settings.
Parameter
Value
Explanation
COS
A waveform whose phase is 90 degrees offset relative to SIN.
FORM TYPE
RND
A random value is output.
NOTE UTILITY Function Added
"NOTE UTILITY"
You can now use
track or drum track.
1.
Press the
[SEQ] button
2.
Hold down the
[SHIFT] button
The STEP EDIT screen appears.
3.
Hold down the
[SHIFT] button
The NOTE UTILITY appears.
Function
Explanation
Raises all notes of the clip by 1 (semitone).
SHIFT NOTE UP
* This function is only for a tone track.
Lowers all notes of the clip by 1 (semitone).
SHIFT NOTE DOWN
* This function is only for a tone track.
SHIFT NOTE LEFT
Moves all notes of the clip to the preceding step.
SHIFT NOTE RIGHT
Moves all notes of the clip to the following step.
QUANTIZE
Quantizes all notes of the clip.
5
– Functions Added in Ver.1.50
Layer the sound of the same pads. Even with
Only one sound can be played at a time when the
The volume immediately starts decaying when
The volume starts decaying when you release the
in the STEP EDIT screen of a tone
to switch the PAD MODE to SEQ mode.
and press a
pad
[1]–[16].
and press a
[FILTER]
button.
Advertisement
