Table of Contents
Advertisement
Starting SCSI Select
Follow these steps to start SCSISelect:
1
Insert the SCSISelect diskette in a bootable floppy disk drive.
(Save this diskette. You may need to run SCSISelect in the
future.)
Note:
The SCSISelect utility is an executable file named
1505acfg.exe on the diskette. If you cannot boot from
this diskette for whatever reason, but you can run
DOS on your system, you can run SCSISelect by run-
ning this file under DOS.
2
Turn on or restart your computer.
3
From the menu that appears, use the
cursor to the option you want to select, then press Enter.
Note:
If you have difficulty viewing the display, press F5 to
toggle between color and monochrome modes. (This feature
may not work on all monitors.)
Exiting SCSISelect
Follow these steps to exit SCSISelect:
1
Press Esc. A message prompts you to exit (if you changed any
settings, you are prompted to save the changes before you
exit).
2
At the prompt, select Yes to exit, then press any key to reboot
the computer. Any changes you made in SCSISelect take effect
after the computer boots.
Configuring the SCSI Card 1505 with SCSISelect
and
keys to move the
13
Advertisement
Table of Contents
