Table of Contents
Advertisement
SCSI Card 1505 User's Reference
05h - Illegal request—The Adaptec formatting utility does not
support a low-level format of this drive; however, the drive
may already be low-level formatted by the manufacturer. (This
error rarely occurs.)
06h - Unit attention—The removable media may be write-pro-
tected. Disable write protection and run the utility again.
I have some older SCSI-1 peripherals installed and my computer is
operating erratically or hangs.
Try changing the following SCSI setting in SCSISelect for your older
SCSI-1 peripheral: Set Initiate Sync Negotiation to No.
The screen is difficult to read when I run the SCSI Select utility.
Press F5 to toggle the display between color and monochrome
modes. This may make it easier for you to read the screen.
I cannot use my SCSI card in a non-Plug-and-Play system.
Check for possible resource conflicts between the SCSI card and
other cards installed in your computer; the cards may have conflict-
ing I/O port address and IRQ settings. Try changing these settings
on the SCSI card one at a time, with Jumper 3 and SCSISelect to iso-
late the conflict.
I cannot use my SCSI card in a Plug-and-Play System.
Try setting ISA Plug-and-Play Mode to Disable in the Advanced
Configuration Options of SCSISelect. Your SCSI card is now a Legacy
card, and you must configure the I/O Port Address and Host
Adapter Interrupt (IRQ) channel manually with the Jumper J3 and
SCSISelect.
8
Advertisement
Table of Contents
