Louver; On Timer; Off Timer; Run Hour Operation Activation / Deactivation - Carrier Aura Owner's Manual

11. LOUVER

Not available in this model

12. ON TIMER

The air conditioner can be programmed to to turn on
in advance.
• Press ON TIMER,
ON TIMER
• Press to set hour.
• Press (v) to set minutes.
• Press ON TIMER button
display will stop blinking.
To cancel this function, press ON TIMER
butoon again. The dot after the 2nd on the
LED will show the status of the timer setting.

13. OFF TIMER

The air conditioner can be programmed to
to turn off in advance.
• Press OFF TIMER, the symbol
start-time display will blink.
• Press to set hour.
• Press (v)
to set minutes.
• Press OFF TIMER button again,
OFF TIMER
and stop-time display will stop blinking.
To cancel this function, press ON TIMER
butoon again. The dot after the 2nd on the
LED will show the status of the timer setting.

14. RUN HOUR OPERATION ACTIVATION / DEACTIVATION

The user can activate or deactivate the
Run Hour target operation. When it is activated and
the unit is on, the unit will run based on the balance
number of hours from the target that was set. When
the set hour target is reached, the dot after the 1st digit
will blink continuously which will serve as an alarm.
• Press and hold
RUN -H
handset for 3 seconds, the LED screen will show
' rd ' which stands for Run Hour deactivated.
The screen will also show the previous target setting.
• To activate, wait for the display to go back to normal
then press button again for 3 seconds until
RUN -H
the ' rd ' re-appears. Immediately press mode from
the unit display board, wait until the unit display ' rA '
The setting will be confirmed immediately.
Do the same thing to deactivate the Run Hour Function,
In case you do not want to use it.
and start-time display will blink.
again and start-time
ON TIMER
and
OFF TIMER
button from the remote
15. RUN HOUR TARGET SETTING
To change the target setting, press the
button. As soon as it displays the last setting, press
the button. The target can be set in a
or
range of 10-990 hours (10 hours each per up /
down press). When the desired value is reached,
press button again to confirm the new target
RUN -H
setting. The Run Hour counter will reset and the
display will go back to normal. If the
pressed to confirm within 10 seconds, the display
will go back to its regular setting automatically and
the target set value will be discarded.
Note:
If the setting is equal to vvor above 100 hours, the dot after
the 1st digit will be lit. The value shown has to be
multiplied by 10.
Examples:
If unit displays 2.4 (with decimal point lit), this means
24 x 10 = 24 hours.
If unit displays 10 (without decimal point lit), this means
10 hours.
16. CHECKING BALANCE
Press button while the Run Hour feature is active
BAL
and the LED display will show the remaining hours
for 5 seconds. If the counter is below 100 hours, the 2-digit
LED will display the remaining hours for 5 seconds. If the
remaining value is above 100 hours, the dot after the first
digit will be lit and the value shown is to be multiplied
by 10. Please refer to example above.
Notes: if the button is pressed while Run Hour
BAL
operation is deactivated, "rd" will be shown at the 2-digit
LED for 5 seconds.
If the counter has reached zero balance, the dot after the
1st digit will blink continuously as the alarm and the unit
will be locked out. You would need to reset the run hour
target setting before you can use the aircon unit again.
RUN -H
button is not
RUN -H