Edid Update; Ddr Settings Update; Mac Address Update; Hotel Mode Setup Menu - Philips VES1.1E Service Manual

23.10.6

Edid update

1. Create a "spi" folder in root of the memory stick.
2. Copy "edid.edid" to the "spi" folder.
3. Connect the USB stick to the TV.
4. Perform USB operations in the service menu.
23.10.7

DDR settings update

1. Create a "spi" folder in root of the memory stick.
2. Rename the ddr binary file to be used which resides in the config_mb62 folder as mb62_ddr.bin.
3. Copy the file "mb62_ddr.bin" to the "spi" folder.
4. Connect the USB stick to the TV.
5. Perform USB operations in the service menu.
23.10.8

MAC address update

1. Create "spi" folder in root of the memory stick.
2. Copy the file "mb62_mac.bin" to the "spi" folder.
3. Connect the USB stick to the TV.
4. Perform USB operations in the service menu.

23.11 Hotel Mode setup menu

The hotel mode setup menu has a normal and a high security mode.
To enter the hotel mode setup menu of a set in the normal security mode, press "MENU 7935" on the
remote control belonging to this set.
To enter the hotel mode setup menu of a set in the high security mode, the yellow service remote control
is needed. To navigate through the menu, the remote control that belongs to the set is needed.
To enter the hotel mode setup menu on a set with high security mode, first put the yellow remote in RC5
mode and then press the "Home/Menu" button.
•
Note: To order a yellow remote, use order code: 22AV8573/00 or 12NC 8670 000 67389.
23.11.1

Hotel TV welcome image update (only available in Hotel TVs)

In the VES1.1E LA the welcome image can be updated:
Copy To USB
There are two steps and both are independent of each other.
Copy the updated welcome image to USB as "hotel_wel.png". Copy NVRAM data (service list,
preferences, etc.) to the USB device. In this chassis all nvram data is stored in 8 × 32KB Flash
files named as Flash0.bin, Flash1.bin ... Flash7.bin. When a Copy to USB is called, those files
are copied from TV to USB. Then they can be used for various purposes testing on another TV
or testing/debugging on observatory etc. Note that USB should be plugged before this
operation.
Copy From USB
There are two steps and both are independent of each other.
If there is file named "hotel_wel.png" in directory "welcome_image". It is copied to the tv to use
as welcome image.
Copy from USB device data to NVRAM. Just the reverse operation is done by a copy to USB
call. Previously copied nvram files (Flashx.bin) are copied into TV. If there is no flash file or
some of them are available on USB, the available ones are copied. If no USB is connected,
nothing happens.
•
Note: For the clone function a USB stick (Copy to USB – Copy from USB) must be formatted to FAT32. If the
USB stick is not formatted to FAT32 the other TVs will not accept cloned data and cause performance issues.