Optional Beeper Indications - Symbol LS 1220 Product Reference Manual

LS 1220 Product Reference Guide

Optional Beeper Indications

Table 8-3 lists the beeper tones used by the LS 1220 when the optional beeper is
configured.
Standard Use
Beeper Sequence
1 Beep - short high tone
4 Beeps - long low tone
Parameter Menu Scanning
1 Beep - short high tone
1 Beep - lo/hi tone
1 Beep - hi/lo tone
1 Beep - hi/lo/hi/lo tone
Code 39 Buffering
1 Beep - hi/lo tone
3 Beeps - long high tone
1 Beep - lo/hi/lo tone
2 Beeps - long high tone
1Beep - lo/hi tone
8-18
Table 8-3. Beeper Indications
A bar code symbol is decoded successfully (if decode
beeper is enabled).
A format or transmission error is detected in a
scanned symbol. The data is ignored. This occurs if a
unit is not properly configured. Check option settings.
Correct entry scanned or correct menu sequence
performed.
Input error, incorrect bar code or "Cancel" scanned,
wrong entry, incorrect bar code programming
sequence; remain in program mode.
Keyboard parameter selected. Enter value using bar
code keypad.
Successful program exit with change in the parameter
setting.
New Code 39 data entered into the buffer.
Code 39 buffer is full.
The buffer is erased, or there is an attempt to
transmit an empty buffer. When the Code 39 buffer
was empty, the scanner read a command to clear or
to transmit a Code 39 buffer.
Error in data transmission.
A successful transmission of buffered data.
Indication