Installation - CDA SL550SS Use And Maintenance

Installation

Important! If installing this oven below a hob, ensure that the
required air gap between the two appliances is observed. This gap
is usually detailed in the hob's manual.
The installation of this appliance must be carried out by a suitably
qualified person. We recommend seeking the help of another
person for the installation process.
Do not install the oven in the direct vicinity of refrigerators or
freezers. This could cause unnecessary energy consumption.
If the oven is being installed into a built
under oven housing unit ensure that
the front rail at the top of the unit is not
installed as it could restrict ventilation.
Ensure that air can flow freely around
the housing area. If the oven is being
installed into a fully enclosed built-under
oven housing unit it may be necessary
to cut a small slot in the top of the
plinth fitted under the unit. Cut a section
400mm wide and a minimum of 15mm high to allow air to pass under
the unit. Alternatively cut a section 400 x 450 mm in the base of the
carcass as indicated in Fig. 12. Failure to allow adequate ventilation to
the appliance may result in overheating or damage to adjacent units
and could invalidate the warranty.
This appliance is type X installation.
30 | Instruction Manual
400
450
600
Fig. 12